Designing Tips for Central Heating Systems

Most homes, especially those that are located in cold regions of the world, install central heating systems to combat the low-temperature weather. One of the most important factors to keep in mind when install heating system is the design. While there are only a few elements needed to design a heating system, all of the elements need the application of heating principles. Doing so may be easy to professionals but apparently unfamiliar to the average homeowner. In this article, we will give you a few tips that can help you design your heating system.

Location on your equipment. A good location for your boiler and the entire central Cv storing heating system is the furnace room, utility room, or basement space. It should be spacious enough for one person to perform required repairs. Install your gas furnaces in locations far from natural gas materials and pipes or anything flammable.

Duct layout design. One thing to keep in mind when designing your duct layout is that your plan should be able to convey heat to areas of your house or building that requires heat. The space that you allot to hot air ducts should include angles that will allow heat to move through ducts smoothly. Avoid designs that may cause obstructions and debris in the ducts. A clear and clean duct facilitates free-flowing of heat. Use galvanized steel ducts to construct the duct system. Ensure that you have these ducts properly insulated to control the heat the escape from the pipes.

Heat output ratio and room space. One prerequisite before designing your system is to study the information about the output capacity of your system as well as the space that you will be heating. If you think that the furnace capacity is low to heat up your space, consider replacing it as early as you can. If you want to heat water through your boiler, you will need to add 3 kW of heat production since hot water will be needed to facilitate cycle through another pipe. During winter, add ten percent to the space to be heated. This will ensure comfortable heat level for your home.

Program modules. Use a thermostat that is equipped with a twin switch especially if you plan to include water heater. The switch has major functions. It signals to the furnace when it should turn on or create hot air. The same signal is initiated to the heater when switching it on and when heating water.

 

 

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *